COMPANY HEADER
Request Information
T1300 - TCXO
Ultra low G-sensitivity; Rugged SMT
Frequency Range: 10 MHz - 50 MHz
Output Signal: CMOS Squarewave
9.14 x 7.49 x 3.71 mm
Unit of Measure

Specifications

Brands

N/A Greenray

Minimum Frequency

N/A 10 MHz

Maximum Frequency

N/A 50 MHz

Output

N/A CMOS Squarewave
Typical Short Term1 N/A 8 x 10-11

Total Gamma G-Sensitivity

N/A ≤7 x 10-11 /g

Positive Slope Typical Frequency Adjust

N/A ±6.0 ppm

Note for Frequency Adjustment

N/A 0 to Vcc EFC, 50 kohm input Z

Ordering Example

N/A T1300-5.0-10.0 MHz
(Model-Input V-Frequency)

Pad Connections

N/A 1 - EFC 12 - EFC Filter Enable (EFC input is through a low pass filter for phase noise reduction. The filter may be disabled for faster response by grounding Pin 12. The filter is enabled if the pin is floating or at logic "1" (+5V)) 14 - 3 - Supply Voltage 7 - 0 V/Gnd 8 - Output Remaining pins are not connected.

Voltage Control

N/A +/-5ppm

Electrical Characteristics

Frequency Versus Supply

N/A ±1 x 10-7 for a 5% Change

Frequency Versus Load

N/A ±1 x 10-7 for a 10% Change

Aging Per Year after 14 Days Operation

N/A ±5 ppm

Warm Up Time in 10 Millisecond (ms)

N/A Within ±1 ppm

Radio Frequency (RF) Output (Sinewave)

Load

N/A 15 pF/10 kohm

Symmetry

N/A 50 %

Symmetry Tolerance (±)

N/A ±10 %

Phase Noise Performance

10 Hertz (Hz) Frequency Offset

N/A -100 dBc/Hz

100 Hertz (Hz) Frequency Offset

N/A -130 dBc/Hz

1 Kilohertz (kHz) Frequency Offset

N/A -155 dBc/Hz

10 Kilohertz (kHz) Frequency Offset

N/A -162 dBc/Hz

100 Kilohertz (kHz) Frequency Offset

N/A -162 dBc/Hz

Note for Phase Noise

N/A Typical 10 MHz, +5.0 V

Direct Current (DC) Supply

Direct Current (DC) Input Supply Voltage

N/A +3.3 V5.0 V

Tolerance for Direct Current (DC) Supply Voltage

N/A ±5 %

Maximum Input Current

N/A 20 mA

Temperature Stability

Temperature Range

N/A -40 to +85 ºC

Tolerance for -40 to +85 Degrees Celsius (ºC) Temperature Range

N/A ±2 x 10-6
  • 1 For 1 sec tau (10 MHz)